| raw2tiff - create a TIFF file from a raw data |
| raw2tiff -w <number> [ options ] input.raw output.tif |
| raw2tiff converts a raw byte sequence into TIFF. By default, the TIFF image is created with data samples packed (PlanarConfiguration=1), compressed with the PackBits algorithm (Compression=32773), and with each strip no more than 8 kilobytes. These characteristics can overridden, or explicitly specified with the options described below. |
| -H <number> |
| size of input image file header in bytes (0 by default). This amount of data just will be skipped from the start of file while reading. |
| -w <number> |
| width of input image in pixels. You must set this parameter. |
| -l <number> |
| length of input image in lines. Will be calculated from the size of input file if not specified. |
| -b <number> |
| number of bands in input image (1 by default). |
| -d data_type |
|
type of samples in input image, where data_type may
be: byte 8-bit unsigned integer (default), short 16-bit unsigned integer, long 32-bit unsigned integer, sbyte 8-bit signed integer, sshort 16-bit signed integer, slong 32-bit signed integer, float 32-bit IEEE floating point, double 64-bit IEEE floating point, |
| -i config |
|
type of samples interleaving in input image, where
config may be: pixel pixel interleaved data (default), band band interleaved data. |
| -s |
| swap bytes fetched from the input file. |
| -L |
| input data has LSB2MSB bit order (default). |
| -M |
| input data has MSB2LSB bit order. |
| -c |
| Specify a compression scheme to use when writing image data: -c none for no compression, -c packbits for the PackBits compression algorithm (the default), -c jpeg for the baseline JPEG compression algorithm, -c zip for the Deflate compression algorithm, and -c lzw for Lempel-Ziv & Welch. |
| -r <number> |
| Write data with a specified number of rows per strip; by default the number of rows/strip is selected so that each strip is approximately 8 kilobytes. |
| pal2rgb(1), tiffinfo(1), tiffcp(1), tiffmedian(1), libtiff(3) |